PEMBUATAN DAN KARAKTERISASI KOMPOSIT LiBOB/MgCl2 DENGAN METODE SOLID STATE REACTION
Abstrak
The manufacture and characterization of the lithium bus Composite (oxalate) borate with the addition of magnesium chloride (LiBOB/MgCl2). Electrolytes as a media transfer ion battery, plays an important role in the charge-discharge process of lithium ion batteries. The basic ingredients used in the study are lithium hydroxide (LIOH), Borid acid (H3BO3), Our acid dehydrate (H2C2O4 • 2H2O) and magnesium chloride hexahydrate (MgCl2 • 6H2O). The method used in this research is solid state reaction or known as solid-solid method. Based on the results of the XRD characterization, shows the peaks of LiBOB experiencing a shift after being added with 2.5%; 5% and 7.5% MgCl2 • 6H2O, in addition it also raises new peaks of magnesium. While the spread of the material is blown the sample appears evenly with the SEM-EDX test, however there are some elements that are experiencing clotting. And the FTIR test showed a change in the frequency of each mass increase of MgCl2 • 6H2O, but did not cause peak changes in each sample. In the EIS test results, obtaining a low electrical conductivity value, due to agglomeration of the material after the addition of elemental magnesium that is ionic. Thus also causes the diffusion of ions to lower.##plugins.generic.usageStats.downloads##
Referensi
Alfredsson, V. 2004. Mesoporous crystals and related nano-structured materials. Diedit oleh O. Terasaki. Amsterdam: Elsevier. Tersedia pada: http://www.fos.su.se/mcrm2004/Program_Workshop.doc. Berutu, Willy Von, Analisis Pengaruh Temperatur Hidrotermal terhadap Sifat Kapasitif Superkapasitor Berbahan Graphene. Surabaya, ITS. 2016.
Arifin, D. E. S. dan Zainuri, M. 2014. “Karakterisasi Sifat Separator Komposit PVDF/poli(dimetilsiloksan) Dengan Metode Pencampuran Membran (Blending Membrane),” Jurnal Sains dan Seni Pomits, 3(2), hal. 36–40. L.L. Zhang et al. dalam Diyan Unmu Dzujah, Charge-Discharge Model Superkapasitor rGO dalam Sistem Elektrolit KCl. Jurnal Ilmu dan Inovasi Fisika Vol. 02, No. 01. 2018.
Al-Mahali, Imam Jalaluddin dan Imam Jalaluddin As-Suyuti. 2000. Tafsir Jalalain. Bandung : Sinar Baru Algensindo Suheryanto, Dwi. Pembuatan Arang Bambu (Bamboo Charcoal) ada Suhu Rendah untuk Produk Kerajinan. Yogyakarta: Bali Besar Kerajinan dan Batik. 2013.
Brunschwig, B. S. et al. 2014. Fourier Transformation of an IR Interferogram. Instorumental Analysis Laboratory. Yulian, Annisa. Produksi Karbon Aktif dari Bambu Andong (Gigantochloa verticillata) Menggunakan Activating Agent ZnCl2 dan CO2. Depok: Universitas Indonesia.
Choi, N. et al. 2007. “Surface Layer Formed on Silicon Thin-Film Electrode in Lithium Bis(oxalato) Borate-Based Electrolyte,” Journal of Power Sources, 172, hal. 404–409. doi: 10.1016/j.jpowsour.2007.07.058.
Choi, N. et al. 2007. “Surface Layer Formed on Silicon Thin-Film Electrode in Lithium Bis(oxalato) Borate-Based Electrolyte,” Journal of Power Sources, 172, hal. 404–409. doi: 10.1016/j.jpowsour.2007.07.058.
Derrick, M. R., Stulik, D. dan Landry, J. M. 1999. Infrared Spectroscopy in Conservation Science: Scientific Tools for Conservation. Diedit oleh T. Ball. Los Angels: The Getty Conservation Institute.
Glusker, J. P. ., Lewis, M. dan Rossi, M. 1994. “Crystal Structure Analysis for Chemists and Biologists,” VCH Publishers, hal. 837. doi: 10.1021/ed072pA73.9.
Hong-ming, Z. et al. 2018. “Synthesis of Lithium Difluoro(oxalate)borate (LiODFB), Phase Diagram and Ions Coordination of LiODFB in Dimethyl Carbonate,” Journal Cent. South Univ., 25, hal. 550–560.
Huggings, R. A. 2009. Advanced Batteries: Material Science Aspects. Stanford University: Springer.
Jullien, C. 2016. “Electrolytes and Separator for Lithium Batteries,” in Lithium Batteries. Switzerland: Springer, hal. 431–460. doi: 10.1007/978-3-319- 19108-9.
Lestariningsih, T., Marty Wigayati, E. dan Prihandoko, B. 2013. “Proses Pembentukan Senyawa LiB(C2O4)2 dengan Variasi Suhu Sintering,” TELAAH Jurnal Ilmu Pengetauan dan Teknologi, 31(1), hal. 39–44.
Li, H. et al. 2011. “Gel polymer electrolytes based on active PVDF separator for lithium ion battery . I : Preparation and property of PVDF / poly (dimethylsiloxane) blending membrane,” Journal of Membrane Science. Elsevier B.V., 379(1–2), hal. 397–402. doi: 10.1016/j.memsci.2011.06.008.
Li, X. et al. 2018. “Effects of Imide−Orthoborate Dual-Salt Mixtures in Organic Carbonate Electrolytes on the Stability of Lithium Metal Batteries,” ACS Applied Materials & Interfaces, 10, hal. 2469–2479. doi: 10.1021/acsami.7b15117.
Linden, D. dan Reddy, T. B. 2004. Handbook of batteries, McGraw-Hill. New York: McGraw-Hill. doi: 10.1016/0378-7753(86)80059-3.
Masaki, Y., Ralph J., B. dan Akiya, K. 2009. Lithium-Ion Batteries, Science and Technologies. Japan: Springer.
Michler, G. H. 2008. “Scanning Electron Microscopy (SEM),” in Electron Microscopy of Polymers. Berlin, Heidelberg: Springer Laboratory, hal. 87– 120.
Mohr, S. H., Mudd, G. M. dan Giurco, D. 2012. “Lithium Resources and Production: Critical Assessment and Global Projections,” Minerals, 2, hal. 65–84. doi: 10.3390/min2010065.
Nicolet, T. 2001. “Introduction to Fourier Transform Infrared Spectrometry,” Thermo Nicolet. USA: Thermo Nicolet Corporation, hal. 1–8.
Park, M. et al. 2010. “A review of conduction phenomena in Li-ion batteries,” Journal of Power Sources. Elsevier B.V., xxx, hal. 1–26. doi: 10.1016/j.jpowsour.2010.06.060.
Priyono, S. et al. 2016. “Ketebalan Anoda Li4Ti5O12 dan Studi Pengaruh Ketebalan Elektroda terhadap Performa Elektrokimia Baterai Ion Lithium,” Jurnal Sains Materi Indonesia, 17(4), hal. 146–152.
Ramachandran, V. S. et al. 2002. Handbook of Thermal Analysis of Construction Material. New York: William Andrew Publishing.
Sakka, S. 2004. Handbook of Sol-Gel Science and Technology: Processing, Characterization and Applications. Diedit oleh H. Kozuka. Osaka: Kluwer Academic Publisher.
Sulistiyono, E. et al. 2018. “Study of Lithium Extraction from Brine Water, Bledug Kuwu, Indonesia by The Precipitation Series of Oxalic Acid and Carbonate Sodium,” in Proceedings of the International Seminar on Metallurgy and Materials (ISMM2017), hal. 020007-1-020007-6. doi: 10.1063/1.5038289.
Sumarno, Ratnawati dan Nugroho, A. 2012. “Recovery Garam Lithium dari Air Asin (Brine) dengan Metoda Presipitasi,” Teknik, 33(2), hal. 66–70.
Suryanarayana, C. dan Norton, M. G. 1998. X-Ray Diffraction: A Practical Approach. New York: Springer Science+Business Media, LLC.
Wigayati, E. M. et al. 2017. “Synthesis of LiBOB Fine Powder to Increase
Solubility,” Makara Journal Technology, 21(1), hal. 26–32. doi: 10.7454/mst.v21i1.3076.
Wigayati, E. M. dan Purawiardi, I. 2015. “Sintesis LiBOB dan Analisa Struktur Kristalnya,” Majalah Metalurgi, V, hal. 81–88.
Wigayati, E. M., Purawiardi, I. dan Sabrina, Q. 2017. “Karakterisasi Morfologi Permukaan pada Polimer PVdf-LiBOB-ZrO2 dan Potensinya untuk Elektrolit Baterai Lithium,” Jurnal Kimia dan Kemasan, 39(2), hal. 47–54. doi: 10.24817/jkk.v39i2.3306.
Wigayati, E. M. dan Purawiardi, R. I. 2015. “Analisis Pengaruh Mechanical Milling menggunakan Planetary Ball Milling terhadap Struktur Kristal dan Struktur Mikro Senyawa LiBOB,” Jurnal Sains Materi Indonesia, 16(3), hal. 126– 132. Tersedia pada: http://jusami.batan.go.id.
Zhang, Y. et al. 2012. “Advances in new cathode material LiFePO 4 for lithium- ion batteries,” Synthetic Metals. Elsevier B.V., 162(13–14), hal. 1315–1326. doi: 10.1016/j.synthmet.2012.04.025.
Zhou, W. et al. 2005. “Fundamentals of Scanning Electron Microscopy,” in Scanning Electron Microscopy, hal. 1–40.
